Japan Radio Co. JLR-8400, Instruction Manual

Page: 106 / 218

4-58
4.13.2 Setting FIX Mode

You can select FIX mode to AUTO, 2D, or 3D.
The selections are as follows:
(1) AUTO:
Positioning mode is automatically switched between 3D and 2D, with the optimal
method being used.
(2) 2D: 2D positioning performed.
(3) 3D: 3D positioning performed.
1. Refer to "4.15.1 Changing to a maintenance mode" and display the maintenance menu.
2. Press the key to select "SENSOR" and "FIX MODE."
3. Press the key to select the FIX mode, and then press the key.
4.13.3 Setting Elevation Mask

If the elevation mask is set, satellites at an elevation lower than the set value will not be used in
positioning.

The elevation mask can be set between 5 and 89 degrees.
1. Refer to "4.15.1 Changing to a maintenance mode" and display the maintenance menu.
2. Press the key to select "SENSOR" and "ELV MASK."
3. Press the key to set the Elevation mask value, and then press the key.
4.13.4 Setting HDOP

If HDOP is set, positioning is only performed if HDOP is lower than the set value.

HDOP can be set to 4, 10, or 20.
1. Refer to "4.15.1 Changing to a maintenance mode" and display the maintenance menu.
2. Press the key to select "SENSOR" and "HDOP."
3. Press the key to select the HDOP, and then press the key.
Procedure
Procedure
Procedure