Japan Radio Co. jlr-21, Instruction Manual

Page: 108 / 148

5-46
[CCRP Output]
The configured CCRP information can be output to external devices. When doing so, select
“CCRP” in the Output sentence by referring to “5.3.7 Data I/O Settings (DATA I/O)”.
In order to utilize CCRP data, a function compatible with CCRP transmission/reception must
be connected.
[CCRP Input]
CCRP information (including ship information) can be received from external devices.
When doing so, set DATA OUT4/IN4 to one of NMEA/CCRP, beacon/CCRP, IEC/CCRP, and
4341/CCRP (Refer to “5.3.7 Data I/O Settings (DATA I/O)”), and connect the signal to DATA
IN4 of the Data IN/OUT2 connector (Refer to P2-27.)
When the data configured in this device is different from the data received from an external
device, the following warning is displayed.
In this case, reset in this device.
* will be displayed in the status bar until the completion of the reset.
Press the CLR key to return to the Main menu.
The following submenus are available.
• SHIP: Select from Valid or Invalid for Ship information.( set invalid if don’t
use information)
• BEAM : Ship’s BEAM(0~70.0m)
• LENGTH: Ship’s LENGTH(0~700.0m)
• SENSOR: Select from Valid or Invalid for SENSOR( set invalid if don’t use
information)
• SNESOR: Select SENSOR number (No.1~9)
• X Set point X for the installation position of a sensor unit. (unit is m)
• Y Set point Y for the installation position of a sensor unit. (unit is m)
• CCRP Select from Valid or Invalid for CCRP ( set invalid if don’t use
information)
• X Set point X for CCRP (unit is m)
• Y Set point Y for CCRP (unit is m)
• Press to return to the Main Menu.
•
If the installation position of the sensor unit is off the ship, the sensor unit installation
position (SENSOR) will be “Invalid”.
In this case, change the position setting onto the ship and reset the SENSOR to “Valid”.
The same applies to CCRP.
Memo