Japan CBM Corporation CMP-10, Service Manual

Page: 15 / 41

CMP-10 Service Manual
CMP-10 Rev. 1.00 P 15/41 Date: 2002.07.25
Phenomenon
The fuse blows out
immediately if replaced.
It blows out during
operation.
(F2 blows out)
Cause
The AC adapter is not
connected.
Battery pack is not
connected.
Battery pack is discharged.
The fuse is gone.
Others
The printer mechanism or
control board is defective.
The motor or driver of the
printer mechanism is
defective.
Check Method
—
Check if the battery
pack is connected.
Connect the AC adapter
and check that the
charge LED is blinking.
Check whether or not
the non-specified power
supply was used in the
past.
Check whether or not
the specified fuse is
used.
Check whether or not
the specified power
supply is used.
Check whether or not
the operation panel
board is connected.
The power is turned on
by disconnecting the
cable of the printer
mechanism.
(Does not operate)
The phenomenon
remains unchanged
after the above-
mentioned check.
The power is turned on
by disconnecting the
motor cable.
(Does not operate)
The phenomenon
remains unchanged
after the above-
mentioned check.
Repair Method
Connect the specified
AC adapter.
Connect proper battery
pack.
Charge the battery
pack.
Use the specified AC
adapter.
Use the specified fuse.
Use the specified AC
adapter.
Replace the cable of the
operation panel board.
Connect the connector.
Replace the printer
mechanism.
Replace the control
board.
Replace the printer
mechanism.
Replace the motor
driver or control board.
Power Supply Failure
The power cannot be
turned on.
(POWER lamp not
illuminated)