POTSwap v1.00 User Manual JA16-UM
Page 16 Rev: P09 Date: 01/03/18
© Copyright 2020 Janus Remote Communications
Specifications subject to change without notice
All Rights Reserved See website for latest revision. Not intended for life support applications.
6. SIM Card Installation continued
3. With the circuit board exposed, the SIM card socket is on the cellular radio module. Slide the card holder
(the top section of the SIM card socket) towards the outer edge of the POTSwap to unlock it (as shown in the
figure below). The card holder is hinged on the outer edge - lift it up and slide the SIM card into the holder, flat
end first, chamfered end up. The gold contacts on the SIM card will face down when the SIM card holder is
closed. Slide the card holder towards the center of the POTSwap to lock the card in place.
4. Slide the board back into the enclosure making sure that the front panel components align properly with the
enclosure openings. Install the four TORX screws and tighten.
Figure 10 SIM Card Socket
SLIDE TO
UNLOCK
Figure 11 Re-Assembled Unit
