OPERATING MANUAL
9
POWER STRIPPER
3
OPERATION
3.3
Starting the machine
The
POWER STRIPPER
comes ready for use Switch on / off with the
foot operating switch
Before beginning work with the machine slice strips into the flooring with
a regular razor knife approximately as wide as the blade attached to the machine.
Connect power supply
BEFORE USING THE MACHINE IN OLD BUILDINGS, ALWAYS CHECK STABILITY OF
THE FLOOR ! Damadges can occur on swinging floors.
When working with the
POWER STRIPPER
always wear HEARING PROTECTION !
3.4
Adjusting the working angle
Depending on the flooring condition of the floor covering that is to be removed, adjust
the blade with a tilted angle between 10 and a max. of 30.
If the adjusted angle is too much for the working condition, the resulting pulsation will
cause the RAPID DULLING OF THE WORKING BLADE.
If the adjusted angle is too little for the working condition, the blade will slip along the
flooring NOT CUTTING.
1. Loosen the 4 self locking nuts (which is position 41) and remove the used
blade.
2. Place the new blade in the same position.
3. Retighten the 4 self locking nuts.
DANGER OF INJURY EXISTS WHEN CHANGING THE BLADE
Always attach safety guard or leather pocket while transporting
and while not in use.
3.5
Changing of the blade
Summary of Contents for 111 095 000
Page 2: ......
Page 10: ...OPERATING MANUAL 10 POWER STRIPPER 4 SPARE PARTS 4 1 Drawing...
