Janome QUILT MAKER PRO, Instruction Manual

Page: 44 / 56

Page 44
Quilt Maker Pro 18 User Manual
201704
Assembly Instructions
Thread Post
1. Screw the nut to the thread post. Add washer. Thread
post into threaded hole (Figure 1 Detail). Tighten
clockwise down to the bobbin winder.
Thread Mast
2. To install thread mast, first slide the thread guide
onto the thread mast (Figure 2 Assembly Detail).
Make sure to orient the pigtail of the thread guide
down, relative to the thread mast. Next screw the
nut onto the threads at the bottom of the thread
mast. Slip a washer over the threaded portion of the
thread mast and screw thread mast into the bobbin
winder base. Position the loop at the top of the
thread mast so it is directly over the spool pin.
While holding the thread mast in position,
tighten the nut at the bottom of the thread
mast.
Position the thread guide over the nut.
Angle the thread guide slightly to the left
toward the bobbin area.Then secure the
thread guide in place using the small hex
wrench to tighten the set screw found in the
collar of the thread guide.
Assembly
Figure 2
Figure 1 and Figure 1 Detail
Assembly
Figure 2 Detail
Thread Mast
Thread Post
Loop
Pigtail Thread
Guide
Nut
Washer
Threaded
hole