Janome OC 6260, Instruction Book, Page: 50 / 52

48
PROBLEMS AND WARNING SIGNALS
When beep sounds and the LED display shows warning signal, follow the guidance below to deal with.
Visual signal
LED Cause and Action
The foot control has been disconnected while sewing.
Turn OFF the power and connect the foot control.
A button is pressed when the machine halts due to the overload.
Wait for at least 15 seconds to recover.
If thread jamming causes overload, remove the tangled threads.
Pattern selection key is pressed after buttonhole is finished but the foot is not raised.
Raise the foot.
Do not use the automatic buttonhole foot to sew any other pattern than buttonhole or darning.
The machine is out of order.
Contact the service center or the store from whom the machine was purchased.
Audible Signal
Beep Beep sounds when:
pip Normal operation
pip-pip-pip Invalid operation
pip-pip-peep Buttonhole is finished.
peep The machine is out of order.