TO ADJUST THE CLEARANCE BETWEEN LOOPERS
When the loopers meet as shown in **B**, the clearance should be between 0 and 0.2 mm (D)
as shown in **A**.
To adjust:
1. Remove the spreader setscrew (E) and the spreader holding plate (F).
2. Turn the balance wheel toward you with your hand to bring the loopers as shown in **B**.
3. Loosen the setscrew (G), and adjust the clearance by moving the upper looper (H) to the back
or front as shown in **C**.
4. Tighten the setscrew (G) firmly.
5. Check the clearance between the upper looper (H) and needle.
6. Set the spreader holding plate (F) and tighten the spreader set screw (E).
21
