76
Warning Messages
Message
Problem/Cause
If a buzzer sounds and the LCD screen shows one of these messages, follow the guidance below.
• The machine will stop after several stitches if the
buttonhole is sewn without lowering the
buttonhole lever.
• The machine is started with the presser foot up.
• The machine will stop if the presser foot is raised
while sewing.
• The machine is stopped while sewing a locking
stitch.
• The twin needle button is pressed when a pattern
unsuitable for twin needle sewing has been
selected.
• An unsuitable pattern is selected when the twin
needle mode has been activated.
Lower the presser
foot and start the
machine again.
Lower the buttonhole
lever and start the
machine again.
Cancel the twin needle
mode, and sew with a
single needle.
Sew until it automatically
stops.
Remedy
• The machine is started soon after it has
halted due to overloading.
• Bobbin winder spindle locks during bobbin
winding.
Wait for at least 15
seconds to restart.
If thread jamming causes
overload, remove the
tangled threads.
Turn off the power and
remove tangled thread.
• The machine is turned on when the needle is in
the down position.
Press the up/down needle
position button to raise the
needle.
• The machine is turned on when the needle is in
the down position and the bobbin winder spindle
is shifted to the left.
Turn the hand wheel to
raise the needle.
• The elongation button is pressed when a pattern
that cannot be elongated has been selected.
• The memory button is pressed when a pattern that
cannot be programmed has been selected.
Select satin stitches to
be elongated.
Select the equivalent
patterns from mode 2.
Summary of Contents for MEMORY CRAFT 5200 -
Page 1: ...Janome Memory Craft 5200 Instruction Manual...
Page 81: ...844 800 020 E...
