77
• The LCD screen shows an abnormal display.
• Power switch is turned on while depressing
the foot control.
• The machine is malfunctioning due to a
problem in its electronic components.
The foot control is disconnected while sewing.
• The start/stop button is pressed after the foot
control has been connected.
Turn OFF the power and
connect the foot control.
Disconnect the foot control
and restart the machine.
Release the foot control.
Contact the service center or
the store from where the
machine was
purchased.
Turn the power switch
off and turn it on
again.
Audible Signals
BEEP
Beep sounds during:
pip
pip-pip-pip
Normal operation
Invalid operation
Message
Problem/Cause
Remedy
to
F1 ERROR
• The sub needle plate mechanism fails to
operate properly.
Raise the presser foot and turn
the power switch off.
Clean the hook area, then turn
the power on again.
It is normal that a faint humming sound is coming out from the internal motors.
Summary of Contents for MEMORY CRAFT 5200 -
Page 1: ...Janome Memory Craft 5200 Instruction Manual...
Page 81: ...844 800 020 E...
