Adjusting X and Y Sensors
To adjust the X and Y sensors:
1. Turn the Power ON to return the carriage to
the home position.
2. Turn the Power OFF and then remove the base
unit (do not disconnect X, Y-motor
connectors).
3. Loosen screw A
q
to adjust dimension Y
w
to 5 mm by moving the Y sensor attaching
plate
e
.
4. Turn the Power ON and make sure if the
dimension Y
w
is properly adjusted. If not,
repeat steps 2 and 3.
5. Loosen screw B
r
to adjust dimension X-1
t
to 69.5 mm and dimension X-2
y
to 3 mm
by moving the X shield plate
u
.
6. Turn the Power ON and make sure if the
dimensions are properly adjusted. If not,
repeat steps 2 and 5.
7. Tighten the screws.
8. Reattach the base unit.
q
Screw A
w
Y (2.5 mm)
e
Y Sensor Attaching Plate
r
Screw B
t
X-1 (69.5 mm)
y
X-2 (3 mm) between the edge of carriage and Arm
u
X Shield Plate
t
y
w
q
e
r
u
37
Summary of Contents for Memory Craft 10001
Page 1: ...SERVICING MANUAL...
Page 42: ...40...
