27
bh SenSor
1.6 mm gap
to enteR adjusting mode
meCHaniCal adjustment
adjusting buttonHole leveR Position
to adjust tHe buttonHole leveR guide:
1. enter the bUttonhole SenSor adjUSting mode. (See below. the lcd ShoUld
diSplay bh Symbol.)
2. remove the face cover (See page 4) and looSen the SetScrew
q
.
3. move the bUttonhole lever gUide So the bh Symbol diSappear when the bUtton
hole lever
r
iS lowered.
tighten the SetScrew.
to adjust tHe buttonHole sensoR Position.
4. attach the bUttohole foot (r)
e
.
5. lower the bUttonhole lever
r
to itS loweSt poSition and open a 1.6 mm gap
between the Slider and the bUttonhole foot.
6. tUrn the adjUSting Screw
t
to the left Until the lcd diSplay bh Symbol.
7. next, tUrn the adjUSting Screw to the right Until the bh Symbol diSappearS.
8. tUrn off the power Switch.
9. attach the face cover.
tUrn the power Switch on while
preSSing the needle Up/down bUtton
and locking Stitch bUtton
SimUltaneoUSly.
preSS the Start/Stop bUtton to
Select the Step “Sc 03”.
q
w
e
r
t
note: if there iS any lint or dUSt in the bUttonhole SenSor Slit, looSen the 2 ScrewS
y
and clean it oUt with a Swab.
y
y
