Janome Continental M7 Professional, Instruction Book

Page: 67 / 144

z
x
c
r
r
e
e
q
w
0.9 cm
r
65
B15 Darning
z
Attach the automatic buttonhole foot R and pull the
button holder all the way out.
Place the fabric under the foot, and lower the needle
at the starting point. Then lower the foot.
q
Button holder
w
Starting point
To adjust the evenness of darning stitches
You can correct unevenness of darning stitches by
turning the stitch width adjusting dial or pressing the “–”
or “+” key.
If the left corner is lower than the right side, turn the stitch
width adjusting dial counterclockwise or press the
“–” key to correct it.
If the right corner is lower than the left side, turn the
stitch width adjusting dial clockwise or press the“+” key to
correct it.
x
Start the machine and sew to the required length, then
press the reverse button. This sets the darning length.
Continue sewing until the machine stops automatically.
e
Reverse button
r
Required length
c
Sew another layer of darning over the first layer, at a
right angle to it.
NOTE:
The maximum darning length is 2 cm (3/4˝) and the
maximum width is 0.9 cm (3/8˝).
To sew the same size darning
When finished sewing, a confirmation message will
appear.
Simply start the machine to sew another layer of darning
stitches in the same size.
To sew the next layer of darning stitches in a different
size, press the X key.
To sew a shorter darning
Sew the first line to the desired length and stop the
machine.
Press the reverse button and start the machine again.
The machine will sew the rest of the darning and stop
automatically.