JPC 100-WEB
www.janitza.de
24
9. 2
Slave devices
In addition to the display settings (
1
), there are also configuration options available for slave
devices on the slave device itself (
2
). These depend on the respective slave device.
As an example the configuration options for the UMG 20 CM slave device are explained be-
low.
Fig. 26: Slave configuration using the example of the UMG 20 CM
1
Configuration on the JPC 100-WEB
2
Configuration on the measurement device
Use this drop-down menu to select which slave
device you want to configure in the JPC 100-WEB.
You can switch between the different measure-
ment channels of the UMG 20 CM quickly using
the arrow buttons.
Use this drop-down menu to assign the slave de-
vice to the master device via which it is connected.
Use this checkbox to define whether the device
measures operating current or residual current
(RCM).
Use this checkbox to activate the low-pass filter
for the residual current measurement
The digital outputs of the measurement device can
be set if the warning (output 1) or alarm (output 2)
threshold is exceeded.
You can define an overcurrent warning and alarm
threshold for each channel.
2
1
3
4
5
3
Actions for all UMGs
4
Save configuration
5
Actions for this UMG
