JANE DRIVE, Manual

Page: 45 / 136

45
EN
G. INSTALLATION FOR CHILDREN FROM 75 TO 105 CM IN HEIGHT AND
WITH A MAXIMUM WEIGHT OF 20 KG, WITH THE INTEGRAL HARNESS
Installing in the vehicle.
The DRIVE safety seat should be installed in the FORWARD
FACING POSITION, preferably on the rear seats of the vehicle.
Before installing the safety seat with the ISOFIX anchors, make
sure that the vehicle seat you have chosen is i-Size compliant or
has the 3 anchor points (2 ISOFIX anchors and the Top Tether
ring).
WARNING: THE FORWARD FACING POSITION IS STRONGLY DIS-
COURAGED FOR BABIES OF UNDER 15 MONTHS OLD
Installing the safety seat in the car
• Extract the ISOFIX anchors (6) by turning the handle (9) found
on the front of the base.
1
.a
• Guide both anchors towards the ISOFIX connection points of
your vehicle and press until both sides are locked in place. Two
green indicators on the sides of the base (8) will confirm that
they are correctly locked in place. If one or both or the indica-
tors are red, try again.
1
.b
• Turn the handle (9) the other way to adjust the safety seat so it
is positioned firmly against the backrest of the vehicle seat.
1
.c
• Lengthen the Top Tether strap (14) until it reaches the ring in
the vehicle and hook it on.
1
.d
• Tighten the strap by pulling the end until a green indicator ap-
pears on the Top Tether tightener.
1
.e
Placing the child in the safety seat
• Loosen the integral harness by pulling the straps (
5
.b ) above
the buckle while pressing the tightener button (
5
.c ).
2
.a
• Unfasten the buckle (
5
.a ). To make it easier to put the child
in the seat, you can pass the straps under the armrests.
2
.b
• Position the child in the safety seat making sure that he is sit-
ting well back and with his back upright. Bring the upper ends of
the buckle together.
2
.c
• Insert them into the clasp and press until you hear them click.
2
.d
• Pull the tightener strap (
5
.b ).
2
.e
!