Jands FP12, Operating Manual, Page: 6 / 20

Equipment Description 2-1
Revision 0.1 – 3 June 1999 FP12 DIMMER USER MANUAL
2.0 Equipment Description
2.1 Front panel layout
Refer to Fig 2.1 (below) for a description of the front panel controls.
1. Channel output sockets (rear panel): The twelve output sockets are each rated at
10 amps.
2. Channel circuit breakers: If a breaker trips during use ensure the fault has been
cleared before resetting.
3. Bank select switches: These switches select the DMX start bank and the Test
functions.
4. DMX IN LED: A red LED indicates the presence of DMX signals. If there is no
DMX signal, the LED will flash at a rate of approximately 2 seconds on - 2 seconds
off.
5. STATUS LED: A red LED flashes in the presence of a fault. In normal operation
this LED should be off.
6. PHASE LEDs: Three blue LEDs (one for each phase) indicate that the three phase
mains supply is available.
➀ ➁ ➂
➃ ➄
➅
Figure 2.1 FP12 front panel layout