Contents
ii
Revision 01 – 3 June 1999
FP12 DIMMER
USER MANUAL
EMC COMPLIANCE
This product is approved for use in Europe and Australia/New Zealand and conforms to the following
standards:
European Norms
Australian / New Zealand
Standards
EN 55014-1
AS/NZS 1044
EN 55014-2
AS/NZS 4251.1
EN 60335-1
AS/NZS 3350.1
To ensure continued compliance with EMC Directive 89/336 and the Australian
Radiocommunications Act 1992, use only high quality data cables with continuous shield, and
connectors with conductive backshells. Examples of such cables are:
DMX:
Belden 8102 100% Aluminium foil screen, 65% Copper braid.
JANDS ELECTRONICS PTY LTD 1999
All rights reserved
DISCLAIMER
Information contained in this manual is subject to change without notice and does not
represent a commitment on the part of the vendor. JANDS ELECTRONICS PTY LTD
shall not be liable for any loss or damage whatsoever arising from the use of
information or any error contained in this manual.
It is recommended that all service and repairs on this product be carried out by JANDS
ELECTRONICS PTY LTD or its authorised service agents.
JANDS ELECTRONICS PTY LTD cannot accept any liability whatsoever for any loss
or damage caused by service, maintenance or repair by unauthorised personnel, or by
use other than that intended by the manufacturer.
JANDS FP Series dimmers must only be used for the purpose they were intended by
the manufacturer and in conjunction with this operating manual.
Disconnect mains power when not in use.
Manufactured in Australia by:
JANDS ELECTRONICS PTY LTD
ACN 001 187 837
40 Kent Rd
Locked Bag 15
Mascot
NSW 2020
Australia
PHONE:
+61-2-9582-0909
FAX:
+61-2-9582-0999
INTERNET: www.jands.com.au
Summary of Contents for FP12
Page 1: ...3...