14
Set Up Instructions
Optional Center Dump Chute
•
Position and secure the Side Dump Chute in the transport position. Locate the Side Plates on the left and right sides of the
door. There are two pre-drilled holes located on each plate. Attach the ears on each side of the Center Dump Chute to the
outward most pre-drilled hole on the side plate using one 3/8” hex bolt, washer and lock nut. Insert the S-hook of the center
dump chute chain into the inward most hole on each Side Plate. (Figure 5)
Lights
•
Mount a Pig Tail Assembly on the back of the Gravity Wagon Using (2) 1-1/2” self tapping screws. (Figure 6)
•
Attach the Wire Harness Storage Bracket and a Pig Tail Assembly to the front of the Gravity Wagon using (2) 1-1/2” self tapping
screws as shown in (Figure 7)
Chute
•
Attach the chute to the Gravity Wagon using (2) 3/4” x 1” hex bolts and (2) lock nuts.
NOTE: Do Not over tighten the bolts, the chute should move freely.
Rear
Front
Pig Tail Assembly
Pig Tail Assembly
Light Cord Holder
3/8” hex bolt
Figure 6
Figure 7
Figure 5
Summary of Contents for 250-7S
Page 22: ...22 Parts...
Page 31: ...31...
