J&M Corporation ROKKER XXR, Installation Instructions Manual

Page: 3 / 11

4. Then route the forward part of this harness under
the frame crossmember in front of the battery, up into
the plastic wire harness holder (that runs all the way
up to the fork-neck) forward all the way to a position
inside the headlight housing. (Photo-D)
5. Push the fuse block back into the frame and rein-
stall the two attachment bolts and tighten.
6. Remove the fuse from the large fuse holder and
connect the 10ga red wire to the positive post of the
battery. Then locate the frame grounding point, just
forward of the battery and connect the main black
ground wire to this frame bolt connection. (Photo-E)
Then re-insert the fuse into the main red fuse holder.
7. Route the right saddlebag speaker wire to the right
side of the frame, underneath the crossmember and
along the frame rail to the rear portion of the saddle-
bag position and secure with tie straps. (Photo-F)
8. Remove the two bolts from the left handlebar
control cluster and by using the longer bolts and spac-
ers provided, mount the Bluetooth controller in position
and secure. (Photo-G)
Photo D
Photo E
Photo F
Photo G