Regulatory
XG3
User Manual
Janam Technologies LLC
10
―
3
Laser Safety Statement This product has been tested in accordance with and complies with CDRH 21
CFR 1040.10 and 1040.11 and IEC 450825-1 Ed 2 (2007) except for deviations pursuant to Laser
Notice No 50, dated June 24, 2007. LASER LIGHT. DO NOT STARE INTO BEAM. CLASS 2 LASER
PRODUCTS. 1 mW MAX OUTPUT: 650nm.
For installation, use and maintenance, it is not necessary to open the device.
WARNING:
Do not attempt to open or otherwise service any components in the optics cavity.
Opening or servicing any part of the optics cavity by unauthorized personnel may violate laser safety
regulations. The optics system is a factory only repair item. WARNING: Use of controls or
adjustments or performance of procedures other than those specified herein may result in exposure to
hazardous visible laser light.
WARNING: Use of optical systems with the scanner will increase eye hazard. Optical instruments
include binoculars, microscopes, eye glasses and magnifying glasses.
The LED output on this device has met IEC62471 LED safety and certified to be under the limits of a
CLASS 1 LED product.
2.5. FCC/EU RF Exposure
This device complies with FCC/EU RF exposure guidelines set forth for an uncontrolled environment.
For body worn operation, this device has been tested and meets the RF exposure guidelines for use
with an accessory that contains no metal and the positions the handset a minimum of 1.0cm from the
body. Use of other enhancements may not ensure compliance with RF exposure guidelines. If you do
not use a body-worn accessory and are not holding the device at the ear, position the handset a
minimum of 1.0cm from your body when the device is switched on.
This device was tested for typical body operation, keeping a distance of 1 cm (0.39 inch) between the
user's body and the device. To comply with RF exposure requirements of the FCC standards, a
minimum distance of 1 cm (0.39 inch) between the user's body and the device is required. Belt-clips,
holsters, and similar accessories containing metallic components from others manufacturers should
not be used. Accessories worn close to the body, without keeping a minimum distance of 1 cm (0.39
inch) between the user's body and the device, and that have not been tested for typical body
operation, may not comply with FCC's RF exposure limits and should be avoided.
2.6. CB Scheme
This device complies with CB Scheme IEC 450950-1
2.7. FCC Part 15 Regulation
Pursuant to part 15 of the FCC Rules, you are cautioned that changes or modifications not expressly
approved by Janam could void your authority to operate the XG3 terminal.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates radiate radio frequency