46
47
ASSEMBLY OF THE THROTTLE LINKAGES INTO BRAKE LEVER
ADJUSTING THE ENGINE CONTROL LINKAGES
Snap On
94033
3x3mm
Set Screw
.....x2
10300
*Use the screw
provided with
your servo .
10759
3x3mm
10300
48
ASSEMBLY OF THE AIR FILTER
Step 1
Step 2
Zip ties
Approx. 1mm gap
(Neutral)
(Throttle High)
(Brake)
Turn on the Transmitter and Receiver, then set the
Engine Control Servo Trim to neutral position.
Adjust the idling adjusting screw on the Carburetor
to open approx 1mm gap.
Idling adjusting
Screw
Adjust both 10300 Engine Control and Brake linkage
accordingly.
Adjust the Engine while it is not running.
Adjust the Servo-Horn mounting position for the
Carburetor to be fully open.
Change the pivot mounting position on the servo
horn in case the Carburetor is not opening fully or
is opening excessively. Or if available on the
Transmitter, adjust the Throttle high end point.
Adjust 10300 so the brakes work smoothly.
If the brakes apply too much or not enough,
adjust 36140 accordingly. Or if available on the
Transmitter, adjust the High-End Brake
adjustment.
Adjust 36140 to change the front or rear brake.
.
Approx. 0.5mm
Carburetor opens fully
36140
10300
NO.6
BAG
NO.8
BAG
94002
3x8mm
Hex Screw
.....x1
Zip tie
40129
40127
40128
40127
3x8mm
40128
*Apply filter oil to the foam
before use.
*Place a 8mm piece of
fuel tube as shown.
*Apply filter oil to the foam
before use.
