6
OPERATING INSTRUCTIONS
HOW DO I USE THE ULTRA 8050D-H CLEANER
NEVER OPERATE THE UNIT WITHOUT WATER IN THE CLEANING TANK
- DAMAGE MAY OCCUR
NEVER USE BOILING WATER - DAMAGE MAY OCCUR
Using the HEATER function.
Pressing the "TC" button starts the built in heater.
The red LED on the left of the control panel will
illiuminate. The water will heat to a maximum of
65 degrees C.
To start the cleaning process press the ON button
(as described in point 3).
If required, you can stop / pause the cleaning
process at any time by pressing the OFF button,
pressing ON again will resume the cleaning and
the countdown will continue.
The program can be reset at any time by pressing
the SET button.
When cleaning is finished, unplug the mains cord
from the wall socket and from the unit, and open
the lid to remove the item(s).
Poor away the water (see note) and wipe the
stainless steel tank with a clean dry cloth.
Note : When emptying, always pour liquid away
via the back, avoiding the ventilation slots / power
inlet on the sides and control panel on the front
face.
This Ultrasonic Cleaner has built in circuit protection to avoid overheating. If
the circuit protection comes on then the right hand red LED will illuminate,
and the unit will not operate. After approx 15 minutes, after allowing the unit
cool down, operation can be resumed by pressing the ON button.
4
5
Summary of Contents for Ultra 8050D-H
Page 1: ...USER GUIDE...