Jamara 006143, Instruction

Page: 2 / 28

2
Try to fit the 5 mm dowel as the leading edge. Use triangle ruler
when drop instant glue to secure the dowel on the W5.
Try to fit the W3 on the main wing as the middle edge.
TOP MAIN WING ASSEMBLY
When satisfy the location; place some heavy thing (1 KG) on
the middle edge. Place a long straight ruler on the leading edge.
Make sure the angle between the ribs and leading edge is 90
degree. Use instant glue to secure the joint places on the lea
-
ding edge.
Press the W16R and makes the ribs fit into the slots. Drop some
instant glue on the joint places.
Please check if there is any joint places need to be secured by
instant glue. Apply some glue on the joint places of leading edge
(dowel) and ribs. Wipe off the excess glue.
Try to fit W5 on the main wing as the rear edge.
Place the W17, W18, W19 on the working table.
Place W20, W21 each 2 pieces on the working table. Please
note the direction. There is one small hole on the W20 and W21.
Place the side of the small hole face the center part of the main
wing.
Make sure the alignment of ribs on the W5. Drop instant glue to
secure them in place.
Try to fit the W17 into the slots on the W15. Drop some instant
glue to secure the W17 in place. Try to fit the W18 between the
middle edge the W17. Please note the angle must be 90 degree.
When satisfy the location; use some instant glue to secure the
W18 in place. Try to fit the W19 into the W17 and use instant glue
to secure it in place.
Try to fit the W16R as the front edge of aileron on the main wing.
Please note: there is W16R (for the right wing) and W16L (for the
left wing). The flat surface must face downward; the thick part
must face the wing tip.
Use A piece of double-side adhesive tape to secure the sand
paper on planking; use it to trim the uneven surface or excess
glue.