JAI TM-1402CL, User Manual, Page: 18 / 42

TM/TMC/RM/RMC-1402 Series
10 Installation
2.2.7 (b) JAI, Inc. Power Cables
If you are using JAI, Inc. power cables such as the 12P-02S, please refer to the 12-pin connector pin-out
diagram in “12-Pin Connector (TM-1402)” on page 6. The cable pin-out diagram is shown in Figure 7 below. The
color-coded leads use Gray for Ground and Yellow for +12V.
Figure 7. 12P-02S Interface Cable (optional)
HD In (White Coax)
Video Out (Red Coax)
VD In (Black Coax)
Power (Yellow)
+12 V
Analog
Frame Grabber
GND (Gray)
}
Jack
12P-02S Interface Cable
Pin# Lead Color Function Pin# Lead Color Function
1 Gray GND 7 Black coax VD Input
2 12V DC 8 White coax shield Reserved
3 Red coax shield GND 9 White coax HD Input
4 Red coax Video 10 Brown RXD
5 Orange coax shield GND 11 Blue Integration
6 Orange coax VINIT IN 12 Black coax shield TXD
Note: Make sure that the unused leads are not touching and that there is no possibility that exposed wires
could cause the leads to short.
2.2.7 (c) Building Your Own Power Cable
Refer to the 12-pin connector pin-out in Section 2.2.2 (a on page 6. Connect the Ground lead to pin #1, and the
+12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of sufficient current to
properly power the camera.
2.2.7 (d) Attaching the Power Cable to the Connector
The 12-pin connector is keyed and will only fit in one orientation. Follow these directions to properly attach
the power cable to the camera connector:
1. Rotate the connector while applying slight pressure until the keyways line up.
2. Press the connector into place until firmly seated.
3. Plug the power cord into the AC socket. This will power the camera up.
2.2.8 Attaching the Analog Video Output
When connecting the TM-1402 to an analog frame grabber or a multisync monitor, use the BNC connector on
the rear panel of the camera. The input of the monitor should be balanced for 75
Ω termination. Standard RG-
59 type coaxial cable should carry a full video signal for up to 100 feet.
The multi-conductor cable 12P-02S from JAI, Inc. can be used to transmit analog video, power, sync. signals,
and serial communication. The mini coaxial leads in JAI, Inc. multi-conductor cables are designed for short runs
of no longer than 100 feet.
Note: Make sure that no extraneous wires are visible which could cause a short.
2.2.9 Attaching the Camera Lens
The TM-1402 camera accepts 1/2" or larger format size C-mount lenses. To attach the C-mount lens to the
camera, carefully engage the threads and rotate the lens clockwise until it firmly seats on the mounting ring.