![background image](http://html1.mh-extra.com/html/jai/sp-45000c-cxp4a/sp-45000c-cxp4a_user-manual_631425068.webp)
SP-45000M-CXP4A/SP-45000C-CXP4A
Setting range
Default value
Description
Configure settings for Lens Communication Control.
0, 1
0
Enable RS-232C for lens control.
ー
115200bps
Set the baud rate during communication.
[Setting range]
0:9600bps, 1:19200bps, 2:38400bps, 3:57600bps, 4:115200bps
0:7bit 1:8bit
Set the data length during communication.
0:None 1:Odd
2:Even
Set the presence or absence of parity bit during communication.
0:1bit 1:2bit
Set the stop bit during communication.
Update LensCommunicationRecvData
Displays data received from the lens to be controlled.
Transfers commands to the lens to be controlled.
Configure settings for Event Control.
Notes
:
- This function can only be used with CXP 2.0 or later.
- Please contact the FG board vendor for the status of the tool's Event
function support.
ー
0:AcquisitionStart
Select the event to send the event message.
[Setting Range]
0:AcquisitionStart, 1:AcquisitionEnd, 6:ExposureStart, 7:ExposureEnd,
22:Error
EventNotification
Off, On
Off
Sets whether or not to send an event message when an event selected by
EventSelector occurs.
ー
ー
When the event AcquisitionStart occurs, the following two data can be
checked.
EventAcquisitionStart
ー
ー
Displays the EventID(0x0102).
EventAcquisitionStartTimestamp
ー
ー
Displays the Timestamp value when an event occurs.
ー
ー
When the event AcquisitionEnd occurs, the following two data can be
checked.
EventAcquisitionEnd
ー
ー
Displays the EventID(0x0103).
EventAcquisitionEndTimestamp
ー
ー
Displays the Timestamp value when an event occurs.
ー
ー
When the event ExposureStart occurs, the following two data can be
checked.
EventExposureStart
ー
ー
Displays the EventID(0x0132).
EventExposureStartTimestamp
ー
ー
Displays the Timestamp value when an event occurs.
ー
ー
When the event ExposureEnd occurs, the following two data can be
checked.
EventExposureEnd
ー
ー
Displays the EventID(0x0133).
EventExposureEndTimestamp
ー
ー
Displays the Timestamp value when an event occurs.
ー
ー
When the event Error occurs, the following three data can be checked.
EventError
ー
ー
Displays the EventID(0x01FF).
EventErrorTimestamp
ー
ー
Displays the Timestamp value when an event occurs.
EventErrorCode
ー
0: No Error
Displays the event error code.
0: No error.
-1: EventAck no response error. This message is displayed when the
EventAck from the host for each event issued cannot be obtained within the
timeout value (200ms).
EventControl
EventSelector
EventAcquisitionStartData
EventAcquisitionEndData
EventExposureStartData
EventExposureEndData
EventErrorData
LensCommunicationControl
LensCommunicationRecvDataUpdate
LensCommunicationRecvData
LensCommunicationSendData
LensCommunicationEnable
LensCommunicationBaudrate
LensCommunicationDataBit
LensCommunicationParity
LensCommunicationStopBit
Item
- 68 -