JAI RM-9730CL, User Manual

Page: 45 / 54

Customer & Serial Commands 37
TM/TMC/RM/RMC-9730CL
9 AccuPiXEL Series Camera Customer and Serial Commands
The AccuPiXEL series cameras can be controlled by serial command either by means of RS-232 or
Camera Link. The Start character is always “:” and the End character is always <CR> (return). For
example, to set Asynchronous Pulse Width Mode, send the command :SA9<CR> to the camera. The
following table contains serial commands that can be used to control the camera.
Table 6 Auto Level Control Commands (Optional-OP1-5)
Command Description Response Comments
:ALC0<cr> Disable Auto Level Control :<ack><cr>
:ALC1<cr> Enable Auto Level Control :<ack><cr>
:ALC?<cr> Enquire Status of
Auto Level Control
:<ack>ALC[x]<cr> x=0 (disabled)
1 (enabled)
:G0=[xx]<cr> Set Default Gain for
ALC:xx=H100H1FF
:<ack><cr> If xx is too high or too low ALC
may be unstable.
:G0?<cr> Enquire Default Gain for ALC :<ack>G0=[xx]<cr> xx=H100-H1FF
K1=[xx]<cr> Set Tuning Factor K1:H100-
H1FF :<ack><cr> Value must compromise both
response time and stability of
ALC performance
:K1?<cr> Enquire Tuning Factor :<ack>K1=[xx]<cr> xx= H100-H1FF
:X0=[xx]<cr> Set Desired Level of
ALC:xx=H100-H1FF
:<ack><cr> If xx is too high or too low ALC
may be unstable
:X0?<cr> Enquire Desired Level of ALC :<ack>X0=[xx]<cr> xx=H100-H1FF
:STF<cr> Save user tuning factors :<ack><cr>
:LTF<cr> Load user tuning factors :<ack><cr>
:LTF0<cr> Load factory default tuning
factors
:<ack><cr>
:LOG0<cr> Set to linear average detection
for ALC :<ack><cr>
:LOG1<cr> Set to Log average detection
for ALC
:<ack><cr>
:LOG?<cr> Enquire if current user is
linear or log
:<ack>LOG[x]<cr> X=0 (linear)
1 (log)