JAI GOX-6409M-PGE, User Manual

Page: 13 / 79

Go-X Series Rolling Shutter GigE Vision I/F (Preliminary)
13
Characteristics of the recommended circuits for Opto OUT
OUTPUT LINE RESPONSE TIME
For the operating conditions of applied voltage (User Power) +12V, load resistance 10kΩ, and
cable length 1m, the timing is shown in the table below.
Item Result (Typ)
TDR
(Time Delay Rise)
(μs) 0.48
RT
(Rise Time)
(μs) 3.08
TDF
(Time Delay Fall)
(μs) 3.16
FT
(Fall Time)
(μs) 52.4
*) Since it varies depending on the applied voltage, load resistance, cable length, etc., check the
actual environment before use.
Caution
Please note that the recommended load resistance of Opto output is 10 kΩ
(rated 1/10 W) or more. The 270 Ω resistor shown in the circuit diagram is the
MINIMUM resistance that should be used. The response speed from On (High)
to Off (Low) depends on the voltage applied to Opto output and the value of
the load resistance. Higher load resistance results in slower response. If the
response at 10 kΩ is slower than desired, you can try reducing the load
resistance in order to increase the response speed but DO NOT go below the
minimum 270 Ω value.
The load resistance loss can be calculated as follows.
load resistance loss ≒ (voltage applied to Opto output )
2
/ (load resistance)
⑦ Camera locking screw holes （ M3, 3mm depth, 12mm pitch ）
Use these holes mounting the camera directly to a wall or other structural system.
⑧ Camera locking screw holes （ M2, 3mm depth, 20mm pitch ）
Use these holes mounting the camera directly to a wall or other structural system.
⑨ Camera locking screw holes （ M3, 3mm depth, 21mm pitch ）
Use these holes mounting the camera directly to a wall or other structural system.