![background image](http://html.mh-extra.com/html/jai/cb-040mcl-ra/cb-040mcl-ra_user-manual_631511025.webp)
CM-040MCL /-RA / CB-040MCL /-RA
22
6.3.4 Reset Continuous (RCT) trigger mode
The RCT mode operates like EPS (edge preselect) mode with smearless function. An
external trigger pulse will immediately stop the video read out, reset and restart the
exposure, then operate as normal mode until the next trigger. After the trigger pulse is
input, a fast dump read out is performed. In the CM-040MCL/ CB-040MCL, this period is
6.77ms which is 215L. The exposure time is determined by the pre-set shutter speed. If no
further trigger pulses are applied, the camera will continue in normal mode and the video
signal is not output. The fast dump read out has the same effect as “smearless read out”.
Smear over highlight areas is reduced for the trigger frame. The reset continuous trigger
mode makes it possible to use triggering in conjunction with a lens with video controlled
iris.
To use this mode:
Set function:
Trigger mode RCT
Scanning
Full, Partial
Vertical binning ON / OFF (CM-040MCL only)
Shutter mode Preset, Programmable
Shutter speed 1/61(OFF) to 1/10000
Programmable exposure 2L to 596 L
Accumulation
LVAL async only
Other functions and settings
Input:
External trigger 12-pin Hirose or Camera Link
Important notes on using this mode
Trigger pulse >2 LVAL to <1 FVAL)
The following table shows minimum trigger interval in asynchronous accumulation mode
Full scan
655 L
2/3 Partial
474 L
1/2 Partial
387 L
1/4 Partial
252 L
1/8 Partial
187 L
1/2 V Binning
360 L
Note: When PE is set at 596 or the shutter is set at OFF, EEN is always HIGH.
TRIG
(55L)
EEN
FVAL
DVAL
Full:1.5114ms / Vbinning:1.6483ms
3L~4L(NORMAL:84us~113us VBINNING:124us~155us)
High speed dump
CCD exposure
Normal
Normal
Triggered
Expsore
Data output by trigger