![background image](http://html1.mh-extra.com/html/jai/141mcl-ra/141mcl-ra_user-manual_3255305030.webp)
CM-141MCL/PMCL/-RA / CB-141MCL/PMCL/-RA
27
6.3.4 Reset Continuous (RCT) trigger mode
The RCT mode operates like EPS(edge preselect)mode with smear less function. An external
trigger pulse will immediately stop the video read out, reset and restart the exposure, then
operate as normal mode until the next trigger. After the trigger pulse is input, a fast dump
read out is performed. In the CM-141MCL/ CB-141MCL, this period is 6.65ms which is 211L.
The exposure time is determined by the pre-set shutter speed. If no further trigger pulses
are applied, the camera will continue in normal mode and the video signal is not output.
The fast dump read out has the same effect as “smear less read out”. Smear over highlight
areas is reduced for the trigger frame. The reset continuous trigger mode makes it possible
to use triggering in conjunction with a lens with video controlled iris.
To use this mode:
Set function:
Trigger mode RCT
Scanning
Full, Partial
Vertical binning ON / OFF (CM-141MCL only)
Shutter mode Preset, Programmable, Fine Exposure
Shutter speed 1/60 to 1/10000
Programmable exposure 2L to 1052 L
Accumulation
LVAL async only
Other functions and settings
Input:
External trigger 12-pin Hirose or Camera Link
Important notes on using this mode
Trigger pulse >2 LVAL to <1 FVAL)
The following table shows minimum trigger interval in synchronous accumulation mode
Full scan
1268 L
2/3 Partial
989 L
1/2 Partial
850 L
1/4 Partial
642 L
1/8 Partial
438 L
1/2 V Binning
744 L
Fig.30 RCT mode timing