JAGO STAN01, Original Instruction Manual

Page: 39 / 54

39
DE FR EN ES EN
S
etting the autoMatic cloSing tiMe
Erase the remote controls
You cannot deactivate individual remote controls but only all
activated ones at once. In order to do so, open the control box,
press the button “AN1” and hold. The “LED2” lamp lights up. As
soon as it goes out, release the “AN1” button. All remote controls
are now deactivated.
Remote
control
Fig. 14
• Check the gate once a month. The gate should be carefully checked for balance. The door
must be in good working condition.
• For safety reasons, we suggest photocells be used on all gates.
• Read the entire manual before attempting to perform any installation or service to the door
operator.
• The manufacturer explicitly reserves all rights regarding technical or other changes, as well
as changes in design.
In case of power failure, use the key, unlock the lock, and
pull down the release bar about 90° to open or close the gate
manually. Use the release key as follows:
• Fit the provided key into the lock.
• Turn the key and pull down the release bar about 90°to
release the gear. (Note: Do not exceed 90°, and be careful
not to use too much force, otherwise the release bar will
be damaged.)
• Open and close the gate manually.
Note: If the gate bumps into the mounting post and cannot be
opened electrically, move the gate a few inches by hand, thus
you can release the gate with the key and open and close the
gate manually.
Fig. 15
Button 1
Button 2
Button 3
Button 4
S
etting the reMote control
M
aintenance
M
anual operation
Open the control box and press the button ‘AN1’ (see Fig. 10), the
‘LED2’ will be on and then turn off, and then press the remote
control button which you want to use, the ‘LED2’ will turn on for
about 2 seconds and then turn off again. The setting process is
now finished.
For each gate control, max. 25 remote controls may be saved.