Jägermeister JEM, Owner'S Manual

Page: 19 / 28

- 19 -
Chapter 6 Plug It In, Turn It On, And Load It!
1. Unsnap the 3 protective dust caps from the bottle well assembly located
on the top of the dispenser. These caps should not be removed and
should be snapped in place when a well space is not being used.
IF THIS IS THE FIRST USE FOR THE MACHINE, REMOVE ANY
ABSORBANT MATERIALS IN EACH WELL. ALSO REMOVE THE
PROTECTIVE CAP ON THE OUTPUT OF THE FAUCET
2. Plug in the power cord of the machine into a 115VAC, 60 Hz. 15 Amp,
3-pronged power receptacle within 5 feet of the rear of the unit.
DO
NOT USE AN EXTENSION CORD OR SURGE SUPPRESSOR.
If the power switch is "ON", the built in lighting will be on. If the lighting
does not come on, turn the power switch to the “On” position.
3. Unscrew the caps from 3 fresh bottles of Jägermeister and insert the
tapered end of the bottle stoppers as described in 'Bottle Stopper
Insertion and Removal" above. The bottle stoppers are spring actuated
and prevent dispensing until they are inserted into the bottle well
assembly.
4.
Place each of the Jägermeister bottles on the top of the machine by
inverting the bottle and inserting the barrel end of the bottle stopper
assembly into the bottle well assembly until the collar of the bottle
stopper rests inside the bottle well assembly flange. The Jägermeister
flow into the machine is automatically activated when the bottle stopper
is placed correctly into the bottle well.
THE MACHINE WILL LOAD A TOTAL OF APPROXIMATELY 1 ½
Liters OR ABOUT 53 OUNCES OF JÄGERMEISTER.
5.
If the power switch is not in the “On” position, place it in the “On”
position. Allow 30 minutes for the system to chill down before
dispensing shots of Jägermeister. When the refrigeration switch is in
the "On" position and the level indicates “F”, the refrigeration
compressor and the condenser fan will begin to run within 2 minutes. It
is very important that the front and the rear of the machine is kept free
and clean of obstructions. Air is drawn from the front of the machine
through a removable filter and exhausted through the rear of the
machine. With the refrigeration switch is in the "On" position and the
level indicates “F”, the refrigeration compressor and the condenser fan
will begin to run within 2 minutes. It is very important that the front and
the rear of the machine is kept free and clean of obstructions. Air is
drawn from the front of the machine through a removable filter and
exhausted through the rear of the machine.
NOTE
THE MACHINE WILL LOAD A TOTAL OF APPROXIMATELY 1 ½ Liters OR ABOUT
53 OUNCES OF JÄGERMEISTER.