60
AURORA Installation instructions
|
jaga
The LEDs in the control panel will flash.
Mount the plug-in connector on the cable of the
power supply and the cable of the device (the
plug-in connector is optional: see page 57).
Remove the cable with the plug from the device
along the top. Then cut the plug from the cable.
06A4
06A5
TURN ON THE MAIN SWITCH!
Hydraulically connect the device.
If you would like to close the device on the left
side, see page 63.
Mount the thermostatic knob.
Connect the plug-in connector and turn until
tight.
Place the grid on the device.
10A8
10A7
10A9
10A10
1
2
MODE
3
4
5
ON/OFF = 3 Sec
= OK
