H 9 6 5 8 6 3
Adjustable Wrench
Phillips Screwdriver
Channel Locks
RECOMMENDED TOOLS
Regular Screwdriver
GROOVE
IN TEE
GROOVE IN TEE
IMPORTANT NOTICE TO THE INSTALLER!
Please check with your local Code Authority for acceptable installation
requirements for this Roman Tub set with hand shower. Some local codes
may require a vacuum breaker and/or a pressure balanced mixing valve to
be installed in conjunction with this product.
1
SPOUT AND T-PIECE ASSEMBLY
Turn off hot and cold water
supplies before beginning.
CAUTION
Grease O-RING
(6
&
7)
. Assemble T-PIECE
(8)
onto the SPOUT SHANK
(1)
and tighten with COUPLING NUT
(9)
.
Slide the T-PIECE
(8)
onto SPOUT SHANK
(1)
until it makes contact with
the O-RING
(6)
. Thread COUPLING NUT
(9)
onto SPOUT SHANK
(1)
.
Rotate T-PIECE
(8)
about 10 degrees from center and tighten securely.
Make sure both O-Rings
(6
&
7)
are seated into grooves of T-PIECE
(9)
.
10°
1
2
3
4
5
8
6
Assemble RUBBER WASHER (3), FIBER WASHER
(4)
and LOCKNUT
(5)
onto threads of SPOUT SHANK
(1)
.
Tighten firmly.
Insert SPOUT SHANK
(1)
through center hole of sink or mounting surface.
Install WASHER
(2)
.
T-PIECE
(8)
and COUPLING NUT
(9)
are factory pre-installed on SPOUT SHANK
(1)
and must be removed to install spout. Unthread COUPLING NUT
(9)
and pull off
T-PIECE
(8).
9
7
Basin Wrench
32mm
(1-1/4" D.)
60mm
(2-3/8" D.)
210mm
(8-1/4")
305mm (12" MAX.)
35mm
1-3/8" D.
NOTE: MOUNTING HOLES
ARE 35mm (1-3/8" D.) for handles
32mm (1-1/4" D.) for spout
3/4"NPT
INLETS
203mm to 305mm
8" TO 12" MAX.
19mm
(3/4" D.)
65.3mm
(2-3/5")
53,7mm
(2-1/8)"
98.4mm
(3-7/8")
ROUGHING-IN
DIMENSIONS
38mm
(1-1/2 " MAX.)
38mm
(1-1/2 " MAX.)
124.8mm
(4-9/10")
216.2mm
(8-1/2")