6
8
7
2
9
10
4
1
CAUTION
Turn off hot and cold water
supplies before beginning.
3
INSTALL HANDLE
Install ESCUTCHEON
(1)
onto ESCUTCHEON HOLDER
(2)
. Apply sealant to groove on back side of ESCUTCHEON
(1)
.
Thread ESCUTCHEON HOLDER
(2)
with ESCUTCHEON
(1)
onto DIVERTER VALVE
(3)
until ESCUTCHEON
(1)
is tight
against FINISHED WALL.
With VALVE in off position align LEVER HANDLE
(4)
as shown. Install LEVER HANDLE
(4)
onto VALVE
STEM
(5)
. Tighten SET SCREW
(6)
with (2.5 mm) HEX WRENCH
(7)
supplied to secure HANDLE
(4)
.
Push in index button
(8)
.
Turn on the water supply. Check that the fitting works correctly and does not leak.
Install ADAPTER
(9)
onto VALVE STEM
(5)
and secure with SCREW
(10)
.
3
SEALANT
5
H 9 6 5 8 8 5
TEST DIVERTER
2
Check that the DIVERTER operates correctly and does not leak.
To do this, screw off the PLASTER GUARD, turn around, and insert using the fluted pin into the
fluting on the DIVERTER SPINDLE and use as a diverter knob.
Screw the PLASTER GUARD back on. Have the wall tiled only with the PLASTER GUARD screwed on.
DIVERTER
DIVERTER
SPINDLE
PLASTER
GUARD
MAX
