40
Jacuzzi Europe S.p.A.
© 2023
Jacuzzi Europe S.p.A.
© 2023
For this special use of the system, please contact our company or an
authorized Jacuzzi service centre.
Management of functions
by means of push buttons
The push buttons provided, make it possible to manage the follow-
ing functions:
- Hydromassage (pump 1:
p1
/ pump 2:
p2
);
- Blower (if present in the system)
(b)
;
- Underwater spotlight(s)
(f)
;
- Water heating (where present)
(rs)
.
1
2
1
2
3
p1
p2
b
f
rs
p2
p1
b
f
rs
Alimia, Sienna
Virginia, Enjoy
Profile Pro
Virtus Pro
p1
f
p2
f
X
To enable the push buttons, you must first activate the sys-
tem with the
"start" key (3)
and then press and hold the
"hand"
key (2)
, for about 3 seconds, until it goes off.
If the "hand" key is already off, it means that the push buttons have
already been activated.
X
When the push buttons are active, the keys of the control
panel are deactivated, with the exception of those dedicated to
programming/settings.
Q
H
YDROMASSAGE
X
Press the
“p1”
button and/or the
“p2”
button to start one,
or both, of the two hydromassage pumps
(the buttons may have
been connected differently during installation).
Each of the two
hydromassage pumps manages a certain number of jets (see
drawings).
X
Press the push button again to shut off the corresponding
pump.
A default maximum operating time of 20 minutes has been mem-
orized. This “timeout” can be modified from 1 to 99 minutes, but it
can also be bypassed. In this case the hydromassage pumps must
be shut off using the pneumatic push button or the main switch, or
with the start/stop key of the control panel. The "timeout" can be
modified only from the control panel, with the system in "standing
by for commands" status ("start" key off) and by means of the sys-
tem parameter
P6(-)
(see information
on setting general system
parameters
).
Values between
01
and
99
represent the maximum operating
time, in minutes, of the hydromassage pumps, after which they shut
off automatically. When set to
0
, the "timeout" is eliminated.
X
When the hydromassage pumps and/or the blower are
switched on, the ozonator (if present) is switched off, and re-
mains off for 15 minutes after the last shutdown (see chapter on
ozonator).
Vice versa, when the hydromassage pumps and/or the blow-
er are turned on, if the filtering pump is off it is automatically
started and kept running for 15 minutes after the last shutdown
(see chapter on water filtering). If the pumps or blower are on,
it means there are people in the tub, and therefore the water
needs to be filtered to keep it clean.
Q
VIRGINIA XP
p1
p2
Q
SIENNA XP
p1
p2
Q
ALIMIA XP
p1
p2
