7
INSTALLATION MANUAL
CAUTION
Make sure to perform the following step
BEFORE
mounting the enclosure onto the mounting bracket,
otherwise, damage to the threaded hole of the mounting
bracket may occur.
7.
Open the front cover of the controller and locate the
fastening hole under the ground bar. Drill a 3/16" hole
through the plastic enclosure.
8.
Line up the slot in the controller enclosure with the
guide in the mounting bracket and hook on to mount.
9.
Secure the controller enclosure to the mounting
bracket with the single fine thread Phillips screw
provided.
Mounting
Bracket
Anchors (4)
Screw
Screws (4)
Controller
Drill a 3/16” hole before
mounting onto the bracket
Figure 1.
MOuNTiNg THe CONTrOLLer eNCLOSure
SECTION 4.
HIGH VOLTAGE WIRING
WARNING
Potentially high voltages in the JAUTPS / JAUTP controller
can create dangerous electrical hazards, possibly causing
death, serious injury or property damage. Turn off power
at the main circuit feeding the JAUTPS / JAUTP controller
to disconnect the power center from the system.
WARNING
Jacuzzi Pool Inc. recommends that any procedure
requiring potential contact with live electrical wiring
and/or parts other than cords and plugs connected to
electrical outlets, should be completed by a contractor
who is licensed and qualified in pool equipment as
described on the front cover of this manual. Failure to
follow warning notices and instructions may result in
property damage, serious injury, or death.
All high voltage wiring must be done by a licensed
electrical contractor.
NOTE:
See
Figure 2. JAuTPS/JAuTP electrical Wiring
Diagram
for specific wire locations
and connections.
