J-200 Series
CAUTION:
Never fill with water from a water softener. If your water
is extremely “hard”, it is preferable to fill half-way with hard water
and the rest of the way with softened water. Or, you may fill entirely
with hard water if you use a special water additive available from
your authorized Jacuzzi dealer.
13. Consult your authorized Jacuzzi dealer for chemical recommendations, then
add chemicals to spa water to achieve a constant sanitizer reading within the lev-
els recommended by the Association of Pool And Spa Professionals/USA printed
on the inside cover of this manual.
14. Turn on all jet pumps when adding chemicals to ensure proper mixing and
leave your spa cover open until the sanitizer level falls below 4.0 ppm to protect
pillows and plastic knobs from chemical attack.
CAUTION:
Never leave your spa unattended for any reason while
the cover is open and accessible to small children and animals.
CAUTION:
To prevent the unlikely possibility of contracting a wa-
terborne illness, maintain water chemistry within step 6 parameters.
If you or other bathers experience such a condition, discontinue use
and seek medical attention.
15. Establish a sanitizer reading between 3.0-4.0 ppm chlorine or 2.0-4.0 ppm
bromine, then allow the spa to set undisturbed for 8 hours. Retest water after
8 hours to determine if sanitizer levels are stable. If sanitizer levels are stable,
your spa is ready for use. To ensure healthy water conditions, always maintain
a constant sanitizer reading within the levels recommended by the Association
of Pool And Spa Professionals/USA printed on the inside cover of this manual.
If sanitizer levels are not stable at this time, it will be necessary to repeat this
procedure in its entirety (steps 1-15) until stable sanitizer readings are achieved.
16. After adequate sanitizer levels are achieved, close all spa air controls by
rotating them clockwise to maximize heat retention when spa is not in use.
19
