J-200
11.1
Programming the Primary Filtration
During the primary filtration cycle, the pump 1 low speed and
CLEAR
RAY
are activated. The hot tub is programmed to cycle 4 times
(every 6 hours) throughout the day, each cycle last 2 hours, and a default
start time of 12:00 AM, but this can be changed.
A.
Primary Filtration Menu
To change the programmed Primary Filtration Cycle:
Note:
If no button is pressed within 5 seconds of each
selection the screen will revert back to the Main Menu and the current
settings will remain active.
1. Press until you get to the
“
PF
”
Menu. The display will scroll
“
PRIMARY
FILTER
.”
After the second scroll, if no action is taken, the
system will revert back to the Main Menu.
2. Press
or
to display the current start time and prepare the
system for changes.
3. Press
or
to adjust the start time, in 1-hour increments. To
switch from “AM” to “PM” you must round a 12-hour period.
4. Press
1
to confirm and save the start time.
5. Press
or
to adjust the number of cycles per day, either 1, 2,
3, 4 or 8 cycles in a 24-hour period.
6. Press
1
to confirm and save the changes.
7. Press
or
to adjust the duration of the cycles, either 1, 2, or 3
hour cycles.
8. Press
1
to confirm and save the duration time. The system will
return to the
“
PRIMARY
FILTER
”
Menu.
In extreme bitter cold weather, where freezing can occur, we
recommend you program the primary filtration cycle to run
for a minimum of 8 hours per day. Refer to the “Winterizing”
section on page 39.
11.2
Programming the Heating Mode
Your hot tub is equipped with 3 modes of heating. An automatic mode
called “AUTO,” where the hot tub’s temperature is maintained at all
times. An energy saving heating cycle called “ECO.” Lastly, a mode that
will only activate the heater during the daytime called “DAY” mode.
• Economy Mode is an energy savings program. The hot tub is allowed
to heat between 5:00 PM and 7:00 AM every day. The hours are not
programmable.
• Day Mode allows the hot tub to heat during the day, between 7:00
AM to 5:00 PM. The hours are not programmable.
• Auto Mode allows the heater to heat, at all times, in order to maintain
the preset temperature.
Note:
The heater will reactivate after the water cools to
approximately 2°F (1°C) below the set temperature.
31
