Jacuzzi ESSENTIAL FOLIA, Use & Maintenance

Page: 30 / 44

30
Sanitization
We recommend the J-MX 07 (*) liquid, offered by Jacuzzi and avail-
able at the Assistance Centres/Authorised Retailers, is used to clean
the tub hydraulic circuit (approximately once a month dependent
on how often the hydromassage is used).
IT is possible to carry out this cleaning operation using the
same water used for the hydromassage provided that soap, oils,
cosmetics,have not been used; otherwise, empty the tub and fill it
once again.
In any case, the tub water level (free of concentrates) must be ap-
proximately 5-6 cm above the highest jets.
„
Pour 50-100 ml of J-MX 07 liquid into the tub.
„
Activate the hydromassage for just over 1 minute; leave the
liquid to act for at least a further 15 minutes.
„
Open the drain and empty the tub.
(*) Product not available in all Countries
Troubleshooting...
„
The hydromassage does not activate
- Check that the main switch is on.
„
The “strength” of the hydromassage has got weaker
- Clean the suction inlet (refer to the Chapter, “Maintenance”).
„
Hydromassage starts accidentally
- Once you have finished using the hydromassage or when there
is a power outage, always turn off the main switch.
- Do not press the button on the side of the tub if the main switch
is off. When the main switch is turned on again, the pump may
start accidentally.
Maintenance
ATTENTION! Before carrying out any maintenance op-
eration, disconnect the appliance from the power sup-
ply line.
„
Cleaning the suction inlet
Remove any residue and wash the various components with wa-
ter and soap.
mod. Silk/Essential
mod. Project
„
Cleaning of the hydromassage jets (Project models only)
Remove any residue and wash the various components with wa-
ter and soap.
„
Cleaning of micro-jets (where included)
Turn the ring anticlockwise, remove and extract the nozzle from
the nozzle body.
Remove any residue and wash the various components
with water and soap.