Jason International, Inc. •
501.771.4477
Page 1 of 16
Customer Service : 800.255.5766
Copyright © 2014 Jason International.
Owner’s Manual
Home spa
InsTallaTIOn, OPeraTIOn, anD MaInTenanCe
49-1014-301
Date 05/2014
“TO Be reMOVeD FOr use BY THe OCCuPanT”
Jason International, Inc.
8328 MacArthur Drive
North Little Rock, AR 72118
www.jasoninternational.com
Owner’s reCOrD
Dealer:
Date Purchased:
Date Installed:
Installer:
PlaCe serIal nuMBer CarD wITH
PrODuCT COnFIguraTIOn In THIs BOx
InsPeCTIOn
Inspect the unit prior to installation. In the event of a
problem, DO NOT install the unit.
All components are factory assembled to the bath and the
unit is water tested and inspected prior to leaving Jason
International, Inc.
If the carton shows sign of damage, inspect the product
before accepting and describe the problem on the Bill of
Lading.
NOTe: Transportation and insurance from Jason’s
factory are the buyer’s responsibility.
Damage sustained in transit is the responsibility of the
carrier.
If damage is discovered,
The carrier must be immediately notified in writing with a
request for a representative to inspect the unit. Failure of
the carrier to respond should be reported to the seller and
carrier. Always file a freight claim promptly.
The installer is responsible for insuring that the unit is
free from defects or shipping damage. In the event of a
problem, DO NOT install the unit.
Jason International is not responsible for damage that
might have been avoided by inspection or testing prior to
installation.
If the carton shows sign of damage, inspect
the product before accepting and describe the
problem on the Bill of lading.
Damage to the unit during installation will not be covered
by warranty and is the responsibility of the installer. ALL
WARRANTY CLAIMS ON ACRYLIC SURFACE DAMAGE
MUST BE MADE PRIOR TO INSTALLATION. Inspect
plumbing and bath surface for missing or damaged
components. Alert your dealer of any discrepancies.
To protect the unit from damage keep the bath in the
carton until ready for installation.
eQuIPMenT aCCess
In accordance with Building Codes, service access to all
therapy bath equipment, controls, and electrical connections
must be provided during installation (See
Table 1 -
Specifications
for minimum access size). Access must be
provided for both the pump/control and the blower/control.
Insufficient access will hinder repair and maintenance.
Warranty service will not cover cost of providing equipment
access.
78 x 78 x 28
90/170
36 x 17 in
70.9
198 x 198 x 71
341/643
91 x 43 cm
346
78 x 66 x 28
80/160
36 x 17 in
64.6
198 x 168 x 71
303/606
91 x 43 cm
315
Min. Size
Access
Floor
Loading
L x W x H (in.)
L x W x H (cm)
Gallons
Liters
lbs/ft2
kg/M2
HSC650 (Round)
1
1.5
HomeSpa COLLECTION (Air Whirpool Bath)
Model
Overall Dimensions
Operating
Capacity
Blower Pump
HSR6555
1
1.5
HP
HP
W x H (in.)
W x H (cm)
Table 1 - Specifications
