![background image](http://html1.mh-extra.com/html/jacuzzi/espree-series/espree-series_installation-and-operating-instructions-manual_3320295013.webp)
Magic Touch
®
Whirlpool Switch
The Magic Touch whirlpool ON/OFF switch, conven-
iently located on the bath, allows you to turn the whirl-
pool system on and off while in the bath. Simply push
down on the switch button to turn on the whirlpool sys-
tem. To turn the system off, push down on the button
again.
If your bath has an optional Jacuzzi Whirlpool Bath
wall mounted timer, set it for the amount of time you
wish the whirlpool to operate. Note: when you desire
less than 10 minutes of whirlpool action, it is necessary
to turn the timer knob clockwise past the number 10
and then back to the desired amount. If the whirlpool
action does not begin when the timer is correctly set, it
is necessary to push the Magic Touch switch button.
All baths manufactured by Jacuzzi Whirlpool Bath are
designed for "fill and drain," which means the bath should
be drained after each use and filled with fresh water by
the next bather. This is a health precaution, as these
baths are not designed to hold water continuously like
pools or spas. If you want a unit designed to continu-
ously hold water, see your Jacuzzi Whirlpool Bath dealer
for the complete line of whirlpool spas available.
Once the bath is installed, remove any residue or for-
eign materials left over from construction. Use turpen-
tine or paint thinner to remove stubborn stains, paint or
tar. Other dirt can be cleaned off with a mild liquid de-
tergent on a damp cloth. Scrape off plaster with a
wooden or plastic edge; do not use metal scrapers,
wire brushes or other metal tools, as they will dam-
age the bath's surface.
Water Level
Close the drain and fill the bath until water is at least
2" above the highest jet (see water line indicated in the
illustration). Do not turn on the whirlpool system at
any time if the jets are not completely immersed in
water. Running the whirlpool system when there is in-
sufficient water in the bath could result in water spray-
ing outside the bath area. Running the whirlpool sys-
tem without water will damage the recirculating pump.
MAGIC TOUCH
¨
WHIRLPOOL
ON/OFF SWITCH
AIR
CONTROL
KNOBS (2)
DRAIN/OVERFLOW
FULLY ADJUSTABLE JETS
TYPICAL BATH FITTINGS
SUCTION
COVER
W
HI
RLPOO
L
DEPRESS CENTER ON/OFF
MAGIC TOUCH SWITCH
PUSH
ON/OFF
OPERATION
2"
FILL TO AT LEAST
2" ABOVE HIGHEST JET
9
Jacuzzi Whirlpool Bath© U961000F 12/04