Hardware Used
EE
BB
CC
DD
AA
6
6.
Install Tank
Install foam gasket (AA) over threaded outlet
on bottom of tank (A) and lower onto bowl (B)
so tapered end of foam gasket (AA) fits evenly
into water inlet opening on bowl (B).
black rubber washer (BB) onto the brass bolts
with round heads (EE). Insert the brass bolts
with round heads (EE) down through the holes
in the bottom (inside) of the tank (A) and through
the bolt holes in the bowl (B)
. With the tank (A)
parallel to the
wall
(standing
level
and upright),
position
large
metal washer
(CC)
and
large
nut
(DD)
on the
brass
bolts with round
heads
(EE)
and
alternately
hand tighten.
DO NOT TURN BRASS BOLTS WITH
ROUND HEADS (EE) WITH SCREWDRIVER
FROM INSIDE THE TANK (A). INSTEAD,
TIGHTEN LARGE NUTS (DD) FROM
BELOW, HOLDING BRASS BOLTS WITH
ROUND HEADS (EE) IN PLACE AS
NECESSARY.
Push down on the tank (A) and alternately hand
tighten large nuts (DD) again, keeping tank
level. Using pliers or wrench (not included),
alternately give the large nuts (DD) another 1/2
turn to level tank (A).
TO AVOID CRACKING THE BOWL (B), DO
NOT OVERTIGHTEN LARGE NUTS (DD).
Foam Gasket
x 2
x 2
x 2
x 1
Black Rubber
Washer
Large Metal
Washer
Large Nut
Brass Bolt
with Round
Head
x 2
B
BB
A
EE
AA
CC
DD
9
Place the
