![background image](http://html1.mh-extra.com/html/jacto/falcon-vortex/falcon-vortex_operators-manual_3181953033.webp)
33
ATTENTION
- Mount all ballasts recommended by the tractor manufacturer before starting to
work with the Falcon Vortex sprayer.
- Before cutting the PTO shaft tubes, check for all possibilities of movement of
the sprayer on the lift arms and third point.
- Make sure the hitch pins locks are correctly installed.
- For instructions in detail, please refer to the section MAINTENANCE - PTO
SHAFT.
CONNECTING THE PTO
drawbar
- Mount the sprayer on the tractor's three-
point suspension and level it as shown in
the figure beside.
h h
± 1.96 in
± 1.96 in
NOTE: Align the forks as shown by "A".
A
height
adjustment
- Adjust the tractor hydraulic lift lever so
that the sprayer is not raised too high.
- Remove or set aside the tractor's drawbar.
- Adjust the PTO shaft. If necessary, cut
the male and female tubes so that, after
connecting the sprayer, it has the overlaps
recommended in the figure beside.