14
07610-004-29-29-A
In order to maintain the dishmachine at its optimum performance level, lime and
corrosion deposits must be removed. The frequency for deliming will be based on
water conditions. A deliming solution is available from your chemical supplier. Read
and follow all instructions on the label.
To delime the dishmachine:
1. Disconnect or turn off all chemical feeder equipment.
2. Verify the drain handle is in the closed position, turn the unit on, and allow the
unit to complete a fill cycle.
3. Open the door and verify water level is above standpipe. Add deliming
solution per the solution manufacturer’s recommendation (the water capacity
of the tank can be verified on the specification page of this manual).
4. Close the door and push the Delime Button on the display.
5. Run the machine for the period of time recommended by the chemical
supplier.
6. Press the Delime Button again and the pump will stop.
7. Open the door and remove the standpipe.
8. Wait five minutes, then inspect the inside of the machine. If the machine is
not delimed, run again.
10. When clean, drain and refill the machine.
11. Open and close the door to run an auto cycle to remove residual deliming
solution.
12. Drain and refill the machine.
DELIMING
DELIMING INSTRUCTIONS
OPERATION
Delime Button