17
07610-004-43-79-Q
OPERATING INSTRUCTIONS
OPERATION
In order to maintain machine at its optimum performance level, lime and corrosion
deposits must be removed. The frequency for deliming will be based on water
conditions. A deliming solution is available from your chemical supplier. Read and
follow all instructions on the label.
To delime machine:
1. Remove rinse arms and place in sink with deliming solution (leave for amount of
time recommended by chemical supplier).
2. Replace rinse arms.
3.
If machine is full of water, close door, press Power button, and allow machine to
drain and shut-off.
4.
Follow Filling the Wash Tub section of this manual.
5. Open door and add amount of deliming solution recommended by chemical
supplier.
6. Close door and press Delime button on display. Status will
display "DELIME."
7. Press Start button.
8.
Machine will delime, drain, and refill.
9.
Wait five minutes, then inspect machine. If machine is not delimed,
run again.
10.
When clean, press Delime button. Status will display "READY."
11. Run machine through two regular cycles to remove residual deliming solution.
12. Machine is now ready for normal operation.
DELIMING
If machine is equipped
with an SPS and lime is
becoming a frequent
problem, the cartridge
needs to be replaced.
To order a replacement
cartridge, see the
Plumbing Options page.
1 5 5
F
D E L I M E
O N
