Jackson 24A-AF, Instruction Manual

Page: 8 / 56

Installation of Model 24 Top and Table gasket:
These instructions are to be used for applying the adhesive backed sponge rubber strip to the top of the
machine prior to setting the table in place.
Included with the Model 24 table is a 6 foot length of 1/4
"
thick x 1" wide sponge rubber adhesive backed
stripping.
Instructions for applying gasket:
1. Place one end of the stripping along the complete
side of the leg support flange and cut it off.
2. Repeat the same procedure along the other side.
3. Place the remaining piece along the front edge, fit it
in between the side pieces and cut it to length.
4. Remove the backing and set the strips in place.
Instructions for installation under a porous
counter top:
1. If possible, a hole should be cut through the counter
top directly above the equalizing vent. A piece of 1
1/4 " OD pipe is then inserted through the hole into the
vent opening and piped to the outside.
2. If cutting a hole in the counter is not possible, then a
piece of stainless steel 36" wide by 36" long bend in
the middle at 90 should be centered directly over the
vent to allow the steam to condense on it when it
comes out of the vent.
3. It is very important that this vent be kept open and
cool air allowed to circulate around the unit.
Installation of Model 24 Dishwasher Under Dishtable:
1. On the end of the table, locate bracket #4 opposite the sink end.
2. A square rubber gasket #3 is supplied and should be secured to top frame of dishwasher with
caulk or suitable adhesive.
3. Place dishtable #2 where it is to be installed and support the machine's end.
4. Slide dishwasher #1 underneath dishtable #2 so that the outside of machine is positioned against
the guide bracket #4. Make sure dishtable and dishwasher are in desired permanent location.