Jackson 24A-AF, Instruction Manual

Page: 24 / 56

TROUBLE SHOOTING GUIDE
PROBLEM CAUSE SOLUTION
Water overflow out bottom of Machine not level. Level machine.
front door when wash pump Slight tilt to rear
is operating. Overflow drain clogged. Remove obstruction, checking
inside of machine first.
Water level in machine's Solenoid valve not closing at
wash reservoir too high. end of fill or rinse cycle
causing excessive water
problem.
Detergent foaming. Reduce quantity of detergent.
Equalizing vent blocked. Allow free steam flow.
Wash motor doesn't operate on Wires broken or loose. Check all wires in the motor and
manual wash. reconnect as necessary.
Defective manual wash Replace.
switch.
Bad bearing, noticeable by Replace.
noisy bearings or locked
drive shaft.
Defective motor starting Replace.
relay. (Typical - motor
hums.)
Note: The motor starting relay is utilized to insert a starting field in the wash pump motor, once the
motor has gained speed, the running winding will then take over and the starting winding will be
removed when the relay kicks out.
Motor runs on manual wash but Defective timer. Replace timer.
doesn't operate on automatic
(rinse operates okay on both
manual and automatic cycles.) Defective circuit in manual Replace switch.
wash switch.
No water comes through the Hand water valve to machine Turn on water valve.
rinse arms when the 'on/fill' not turned on.
switch is depressed.
Defective coil on Replace coil.
solenoid valve.
Probes are dirty or coated. Clean probes.
Defective water level control. Replace.
Little or no water coming Limed up rinse heads or Begin by cleaning rinse heads
through rinse assemblies. piping. using instructions for de-liming.
If this isn't satisfactory, then
clean the rinse feed pipes.
Water pressure low. Increase pipe size to machine.