15
TECH
-
TIP
Remove Warming Rack before
using your rotisserie burner;
otherwise the rack may be
damaged due to excessive Heat
.
4.
FLAME CHARACTERISTICS: (Fig. 13)
•
Check for proper burner flame characteristics. Each burner is adjusted prior to shipment; however,
variations in the local gas supply may mean subtle adjustments may be necessary.
•
Burner flames should be blue and stable. There should be no excessive noise, or flame lifting. If any of
these conditions exist please call your Dealer. If the flame is yellow, it indicates insufficient air. If the flame is
noisy and tends to lift away from the burner, it indicates too much air.
•
Note small yellow tips are okay
5.
LIGHTING THE ROTISSERIE BURNER:
•
Open lid during lighting.
•
Turn all knobs to “OFF” then open the propane cylinder valve
or the natural gas valve at the natural gas quick release.
•
Push and turn rear burner control knob to
(high) then push
and hold igniter button until burner lights. Ignition should occur
within 5 seconds.
•
If burner does not light, wait 5 minutes for gas to clear and try again.
•
Follow match lighting instruction if burner can’t be lit after repeating above
steps 3
-
4 times.
•
Once the burner is lit, the rotisserie burner will attain a red glow across its entire front
surface.
•
DO NOT run the rotisserie burner with the main burners.
6.
LIGHTING THE ROTISSERIE BURNER BY MATCH:
•
Read instructions before lighting.
•
Open the lid during lighting.
•
Push and turn the rear burner knobs slowly to
(high position, then
release.
•
Light by match with left hand. Make sure the burner lights and stays lit.
Grilling and Rotisserie Cooking:
TOTAL GAS CONSUMPTION:
Total gas consumption per hour, per burner:
MODEL JLS700 (ALL)
:
Main burners:
15,000 Btu/hr. X 4
= 60,000 BTU/hr.
Rear burner:
13,500 Btu/hr. X 1
= 13,500 BTU/hr.
Total:
= 73,500 BTU/hr.
Problem Flames
: lifting off,
‘ghosting’ and disappearing;
check shutter settings. (see p. 20)
Excellent Flames
: mostly blue,
small amount of yellow is okay;
flames are even sized and calm.
Problem Flames
: uneven,
blasting, noisy with lots of yellow;
check for burner blockage, foreign
material, insect nests (pp. 19, 20)
. . . . . . . . . . . . . . . . .
Figure 13
Main Burner
Summary of Contents for LUX700
Page 21: ...21 Exploded View LUX JLS700 57...
Page 45: ...45 Vue clat e LUX JLS700 57...