14
Installer Final Check List
At least 36
” clearance maintained from combustible constructions to the sides and back of this grill.
There is no unprotected combustible construction over the grill.
All internal packaging removed.
Burners are sitting properly on orifices.
Knobs turn freely.
The regulator & hose connected to grill is provided by the manufacturer (pre-
set for 11.0” water
column).
Unit tested and free of leaks.
User informed of gas supply shut off valve location.
DEAR CONSUMER, PLEASE KEEP THIS MANUAL FOR FUTURE USE
。
Grill Lighting Instructions
BEFORE LIGHTING:
Carefully i
nspect the gas supply hose before turning the gas “ON”. If there is evidence of cuts, wear, or
abrasion, it must be replaced before use, the replacement hose assembly shall be that specified by the
manufacturer.
VERY IMPORTANT: ALWAYS INSPECT THE HOSE BEFORE EACH USE OF THIS GRILL.
TO LIGHT MAIN BURNERS OF THE GRILL:
1.
Read instructions before lighting.
2.
Turn all knobs to
“OFF” then open the L.P. tank valve. Always keep your face and body as far from
the grill as possible when lighting
.
3. Open lid during lighting.
4.
Push and turn any control knob
slowly
to “HI” position. The built-in igniter will click and spark
simultaneously to light the pilot and burner in sequence. Turn the control knob to OFF
IMMEDIATELY if the burner does not light within 5 seconds, wait 5 minutes for gas to dispel, then
repeat the lighting procedure.
5.
Follow match lighting instructions if burner can
’t be lit after repeated 3-4 times.
TO LIGHT A MAIN BURNER BY MATCH:
1. Read instructions before lighting.
2. Open the lid during lighting. A long match must be used to reach the burners.
3.
Push and turn the main burner knob slowly to
“HI” position, then release.
4.
Light burner by match. Make sure the burner lights and stays lit.
Keep a spray bottle of soapy water near the gas supply valve and check the connections
before each use. Do not light the grill if odor of gas is present, call our service center
FLAME CHARACTERISTICS:
Check for proper burner flame characteristics. Each burner is adjusted prior to shipment; however,
variations in the local gas supply may take subtle necessary adjustments.
Burner flames should be blue and stable. There should be no excessive noise, or flame lifting. If any of
these conditions exist please call your Dealer. If the flame is yellow, it indicates insufficient air. If the
flame is noisy and tends to lift away from the burner, it indicates too much air.
NOTE: small yellow tips are ok
