Note:
The running time of the E1500 for the following equipment are tested in the laboratory, which has strict controls on
temperature, the working hours can also be affected by many other factors.The actual working time = 1488Wh* 0.85 / operating
power of your device.
For inductive load devices:
What is the inductive load device?
Inductive Loads, also called Lagging Loads or Inductive Load Banks or Inductive Reactive Loads or Power Factor Loads, are AC
loads that are predominantly inductive in nature so that the alternating current lags behind the alternating voltage when the
current flows into the load.
The inductive load device has an instant start power when the it runs. Typically starting power is 3 times the amount
of power to run the application.
When you check if the E1500 can run the device, please kindly check if there is an instant start power.
GIVE YOUR APPLIANCES MORE RUN TIME
Charging
RUN TIME
Motion Camera
(5W max)
Car Fridge
(60W)
Coffee maker
(1120W)
Hair Dryer
(2000W)
Toaster
(650W)
Drone
(90W max)
About
90 Hours
About
68 Minutes
About
50 Minutes
About
130 Minutes
About
27 Recharges
About
246 Recharges
Input Power
Output Power
It shows that Explorer 1500 is recharging from
solar panel.
It shows that the Explorer 1500 has been drain out.
Please kindly charge it to 100% and then use it.
It shows that Explorer 1500 is being recharged.
It shows that Explorer 1500 is charging other
devices.
It shows that Explorer 1500 is charging other
devices through AC port outlets.
When the Explorer 1500 is recharged, the small squares
in the orange circle will light up clockwise; When
charging other devices, the orange circle stays on.
Hz
V
Power Display
It shows that Explorer 1500 is recharging from
wall outlets.
It shows that Explorer 1500 is recharging from
the car.
It shows that the Explorer 1500 is used in a high
or low temperature. Please use E1500 within a
ambient temperature-10~40℃.
